Zektor HD800-V2 Uživatelská příručka stáhnout pdf (Strana 40)

HD1600V2 Serial Protocol, Version 1.4, 10/30/13

Advanced Control

^FS settings$ Reset the parameters indicated by ‘settings’

Response String:

There is no response string to the FS command, this command is write only.

Where ‘settings’ is a bitmapped parameter defined as:

Bit-0 - Reset zone input/output mappings, and power state

Bit-1 - Reset switching delay times

Bit-2 - Reset LED levels and mode

Bit-3 - Reset control settings (the XS command settings)

Bit-5 - Reset IP parameters

Bit-15 - Reset HDMI settings: Clear EDID and HDCP caches, clear HDCP key counts and the EDID lock state.

Note: The HD1600V2 must be turned on before sending the “Reset HDMI settings” (Bit-15), and the

switch must be power cycled (using the ‘P 0’ and ‘P 1’ commands) before the cleared settings take

affect.

All other bits are reserved and should be set to 0 when issuing this command.

‘LI’ Lighting Mode and Intensities

This command uses a bitmapped parameter. Each bit can set or reset without affecting the other bits.

(See:

“Using Bitmapped Parameters” on page 27, for more information on using bitmapped parame-

ters.)

Allows changing the behavior of the front panel LEDs, and adjusting their intensities.

^LI mode,dim,bright,off$ Set mode and intensities

^LI ?$ Query for current settings

Response String:

^=LI mode,dim,bright,off$ Set mode and intensities

Where:

mode = Lighting mode (Settings: 0=Off, 1=Dim, 2=Bright, 3=Auto-dim)

dim = Intensity of dimmed LEDs (Range: 0-100)

bright = Intensity of brightened LEDs (Range: 0-100)

off = Intensity of the standby power LED (Range: 0-100)

Response Example:

^=LI 3,020,090,010$ Mode=Auto, dim=20%, bright=90%, off=10%

The mode settings allow you to set the front panel LEDs to always be: 0 - off, 1 - Always at the ‘dim’

intensity, 2 - always at the ‘bright’ intensity, or 3 - auto-dim from ‘bright’ to ‘dim’ when the front panel

is not in use.

The intensities range for 0, which of off, to 100, which is full intensity.

When setting parameters, not all parameter have to be present, if a parameter is not present, it will be

left unchanged. For instance to change just the ‘bright’ value to 50%:

^LI ,,50$ -> Set the ‘bright’ intensity to 50%

Only the ‘bright’ intensity is affected.

Value

32768 16384 8192 4069 2048 1024 512 256 128 64 32 16 8 4 2 1

Bit

15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46

Komentáře k této Příručce

Žádné komentáře

Zektor HD800-V2 Uživatelská příručka Strana 40

Komentáře k této Příručce